b'The easy-to-use interface in the Haas control guides you through a simple, step-by-step setup03process that teaches the APL arm its positions, and has you fully automated in minutes,Pallet Pool Systemsloading and unloading parts for unattended machining. 6-Station for EC-4008-Station for UMC-750/1000/SS 6-Station for VC-400/SS8- or 16-Station for UMC-500/SSEASY-TO-USE APL INTERFACESIMPLE TO OPERATE IN APL MODE Our easy-to-use APL interface uses simple, step-by- APL Mode seamlessly combines the part program step instructions to help the operator teach theselected in Memory [MEM] with a designated APL APL the correct positions for picking up, loading, andsetup template to automate part production and boost unloading parts. productivity. The APL is operated directly from the machinesAPL Mode:pendent, allowing seamless integration.Simply replace your M30 with an M299 at the end of yourStep-by-step instructions and graphics help guide thepart programoperator through the setup process: From the Run Job tab, press [INSERT] to select the designated Setting up the Haas Automatic Parts Loader (APL) on a VF-2YTSet part template patternnumber of rows and columns APL setup template (Job) and turn on APL Mode; an APL Mode watermark will appear over your program, and youre ready to goHaas Products and Tech Supervisor Andrew Harnett Set first part pick-up positiondemonstrates how to move the mill APL arm to pick up,Press Cycle Start, and the APL will load the first part, and executeSet staging position for APL to wait until machining is completethe part program in Memoryload, and unload the part, and shows how to record each of those positions in the control, so the APL can run Set load and unload positions at the electronic vise While the part is being machined, the APL will drop off the automatically in conjunction with your milling program.Set part drop-off position for the first completed part completed part, and then pick up new raw stock and stage it at the designated load positionThe operator can monitor table status, the number of parts completed, which number part is inside the machine, and whichpart is nextThe cycle continues until all parts on the table are completed, or a specified number of parts is reached21'